Heath-consultants Heath Data Recorder (HDR) Uživatelský manuál stáhnout pdf (Strana 21)

Set Access Control (This sets the security passwords of the instrument)

1. In HDR Host, Go to the Configure Column/ “Set Access Control” in the instrument.

2. The “Host Setup” screen (See below) allows setting up the password in the computer. When the “Host” password

matches the “instrument” password, access is granted & no password will be prompted. If these don’t match, a

password window will be prompted.

Note: This password will typically be the same for all devices so that one password entered in all instruments and

all technicians’ laptops will allow password free access to any instrument in the system.

3. To use the “Readonly” mode: Set the HDR Host/ Host setup “Default Logon Password” to “readonly”. This will

allow a user to see data but not change any configuration or calibrate (Config & Calibration columns are removed).

Reset Instrument (Allows resetting: All Alarms, Fast loggers 1,2,3, Profiler, Fault log (Clearing the Fault log

also clears an instrument Fault) , Configuration log, Pulse inputs & outputs, watchlog or “All the above”. All

stored data will be erased. Go to: “Configure” column/ “Reset Instrument”/ select what to be reset in the

instrument.

Note: This option will NOT erase the HDR firmware, Configuration, Transducer Coefficients or Site Info.

Erasing the profiler WILL erase the stored data file in the HDR. Use this feature while setting up a new unit.

Note: “logon” and “readonly” are the instrument’s

defaulted passwords. These can be changed to be

more secure.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 44 45

Žádné komentáře

Heath-consultants Heath Data Recorder (HDR) Uživatelský manuál Strana 21